High build polyester spray filler, grey.Polyester finishing filler applied by pneumatic spraying. Once mixed with the hardener, the product gains spray viscosity. Allows a high fill ratio to be achieved leaving a smooth surface, even on very large areas. Ready to sand after approx. 2 hours at 20oC (this can be reduced by heating to a maximum of 60°C). The product is intended for machine sanding, as well as for manual sanding with fine-grained abrasive paper. If need 5% polyester thinner. 1 l = 950 ml P60S + 50 ml hardener PS
Thinner: Mipa PE-Thinner