Mipa Vorreiniger "Mat & Clean"-it is a combination of scuffing and cleaning gel for preparing original or refinish  paints prior to fading out base coats and/or applying clear coats, single colour top coats or  blending out clear coats and single colour top coats. 3M recommends that the product is used  in conjunction with 3M Scotch-Brite Copper or Grey Scuff Sponges or Multi-Flex pads.  Product highlights:   Micro crystals provide a homogenous matt surface allowing better overall paint  adhesion   Up to 50% faster than with Scotch-Brite alone   Natural cleaning agents remove wax, grease, tar, silicone, tree resin and water-borne  contaminates leaving a clean non-greasy surface  3) Physical Properties  Flash Point: >93.3ºC  VOCs: 30.9gms/litre  pH Approximately 8.0  Viscosity: Approximately 15,000 cps  4) Directions for Use  Flatting pastes/gels are used to increase the matting performance of Scotch Brite by as much as  50%. 3M Scuff-it will also clean tar and resin residues, etc. It is recommended to use 3M Scuffit with either Copper or Ultrafine (Grey) Scotch-Brite Scuff Sponges, or Pre-cut or Multi-flex  sheets. The Copper Scotch-Brite will give a slightly finer finish, the Grey will give slightly more  aggression.